You can use a light colored pen so that it any remaining ink doesn’t show up much, or you can remove remaining traces of Sharpie ink with rubbing alcohol.Īnd of course, you can always still use eggs. You can also use the Eggbot to transfer a design to the pumpkin for later carving. Keep a slip of paper handy to bleed some ink onto before starting. Getting your ink flowing just before you start plotting is always a good idea, and especially so with glossy skinned pumpkins. It improves your precision and keeps the motors moving smoothly in spite of the huge heavy pumpkin they’re turning. When working with larger objects, especially in the Ostrich Eggbot, slowing the pen speed significantly may be necessary. The rubber coupler on the plunger of the Original Eggbot grips into the stem end quite well. It helps to have a large surface area to couple to the smooth skin of the pumpkin, so using the precision egg coupler is a really good idea. Once there is a flat surface to work with, you’ll be ready to put your pumpkin in the Eggbot. You won’t want to pick a pumpkin for the Eggbot based on its awesome handle-like stem. You can use a saw, a knife, a power sander, or many other tools to make a smooth surface on the stem for the Eggbot to couple to. Most pumpkins will have a rough stem that won’t fit well in the Eggbot’s couplers. They also may need a broader range of pen up/down motion to allow the pen to fit into the deeper grooves. Ones with deep grooves can be challenging, as the pen may leave gaps (like the one on the eye of the jack-o-lantern above) as it moves quickly down into the groove. Mini pumpkins usually fit well, and often have smooth stem-free top which is easy to fit into the Eggbot. Some decorative gourds have very smooth skin, which is nice, and can be interesting shapes, from pear, to ghost-like to very round. Overall symmetry makes things easier, too. Pie pumpkins tend to have a little less “character” than pumpkins sold for jack-o-lanterns, and tend to be quite a bit smaller, so they are a good choice. Smooth pumpkins are easier to work with, as grooves and bumps can be difficult for the pen to navigate. The larger pumpkin above is a little under 6″ in diameter, and the little round pie pumpkin and the mini-pumpkin are about 4″ in diameter. Take a tape measure with you and remember that the Original Eggbot fits objects up to 4.25″ in diameter and the Ostrich Eggbot can fit objects up to 6.25″ in diameter. The first step is to choose your pumpkins carefully. ![]() We first demonstrated printing on pumpkins with an Eggbot last year at Maker Faire New York. In preparation for Halloween, we’ve gathered our tips and tricks for plotting on pumpkins with an Eggbot.
0 Comments
Leave a Reply. |